If you want hot water in the home, then you’re going to need a hot water heater. It could be a gas heater or one that operates using electricity. When you begin the process of installing the heater in the home, there are a few tips that you might want to keep in mind so that it’s connected the right way and so that it operates the way that it should, delivering hot water across the home. An option is to consult a water heater installation Gloucester VA company to have someone come to the home to do the work for you.
Most of the tanks that you purchase will last about 10 years. When your tank begins wearing down, it will usually start leaking around the base or stop heating the water that’s inside. Make sure that you have the proper tools needed for installing the heater and that the water is turned off in the home. It’s also a good idea to turn the power off for a few minutes while the unit is being connected so that there isn’t a risk of damage to the unit or injuries to the person who is connecting it in the home. Check the water pressure to see if it’s too high to flow through the heater. If the pressure is over 80 PSI, then it’s a good idea to turn it down to about 60. There won’t be as much stress on the lines and the heater, which will allow for them lasting longer.
If there’s already a heater in the home that doesn’t work any longer, you need to remove it, disconnecting the lines that supply water through the home. Once the unit is removed, you can begin installing the new unit. You want to make sure the old unit is empty before it’s removed from the location. The new water heater should be placed in a drain pan to prevent water from getting on the floor if there is a leak. Connect the hoses and pipes like they were on the old unit, turn the water on as well as the electricity, and wait for a few hours to see if there is hot water. If the water doesn’t get hot, then check to see if any valves need to be turned on or if there are issues with the unit itself.